![]() ![]() ![]() High time resolution may not be critical if very slow changes are studied, and a high measurement sensitivity may not be important if large changes are to be measured. What aspect to prioritize depends on the studied surface interaction process. All specifications are subject to change without notice.Īpplying a higher sample rate inevitably leads to higher noise and thus a compromised limit of detection (LOD). The specified temperature stability may not be reached if the room temperature changes more than ± 1° C, if there is a draft or a heat source nearby. * The temperature stability depends on variations in how the ambient affects the warming or cooling of the chamber. The power supply should be properly grounded Decimal separator, full stop or commaĮlectrical data Power supply and frequency Windows 10 or later (earlier Windows versions may not fully work and support cannot be guaranteed)ĬSV files. Performance characteristics Maximum time resolutionģ00 datapoints per second (each datapoint represents an f and D value)įrequency: 1366×768 px screen resolution, > 4 GB RAM ~ 10 μl using add-on module (QSense Open module)Ģ5-150 μl/min applicable for QSense setup (Peristaltic pump settable to 0-1 ml/min) Sample and fluidics Minimum sample volume, stagnant mode Measurement range and capacity Measurement channelsġ5 to 65 ☌, 4 to 150 ☌ using accessory chamber (QSense High Temperature chamber)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |